Central Heating

As a approved Glow worm installer we can help design and install complete heating systems or boiler replacements.

 

We can offer a extended 5 year warranty on all our Glow worm boilers that we install, subject to some condtions.

 

We can arrange all the required trades help the project run smoothly.

 

Contact us now for a free no obligation estimate.

 

 

Magnaclean filter

Help reduce your heating costs by installing a Adey Professional Magnaclean filter

The benefits of this new technology are immediate:

  Effective magnetic and efficient non-magnetic filtration
  Simple installation and effortless servicing saving time and money
  Immediate results & system protection cutting heating energy bills
by up to 6% a year*
  Long operational life AND guaranteed for TWO years
  Reduced carbon emissions
  MagnaClean Professional 22mm available in black and white
  More than a million MagnaClean filters installed throughout the UK
*Independent research carried out by GASTEC at CRE.

Powerflushing

What is Power Flushing?

Power flushing is the most efficient method of cleansin a central heating system. The principle is to create a powerful fresh water flow under controlled conditions to remove debris from the system. By connecting the power flushing unit to the heating circuit in place of the system pump, boiler or radiator the circuit can be thoroughly cleansed of limescale and corrosion debris. When used in conjunction with a Fernox cleanser a typical power flush can be completed in 3-4 hours.



The problems

Fuel Wastage

Without treatment, corrosion debris will accumulate in the boiler causing increased limescale deposits, reduced heat transfer and up to a third of a fuel bill going to complete waste.

Boiler Noise

This increases in frequency and intensity as deposits of sludge and scale build up in an unprotected boiler.

Cold Spots

The familiar cool low central area of a radiator indicates a build-up of black sludge sediment that restricts flow and reduces heat.

Frequent Venting

When the top of a radiator is cold during operation, either air or hydrogen is to blame. Hydrogen gas builds up as a by-product of electrolytic corrosion and is flammable (due caution is required)

Pump Seizure and failure

The abrasive and magnetic properties of black oxide sludge increase shaft and bearing wear in pumps causing them to stick or fail.



The cleaning and treating of central heating systems

All new systems should be pre-commission cleansed in accordance with BS:7593 and Benchmark. This ensures flux residues, excess jointing compounds, mineral oil and other contaminants that can be found in the system following installation, and that can effect the performance of the system or cause component failure, are removed. It is important when installing new boilers into old systems that all sludge is first removed from the system or this could accumulate in the new boiler and lead to premature failure. Additionally, in hard water areas existing systems will have accumulated limescale together with corrosion deposits in the heat exchanger, which could easily have reduced the boiler efficiency by over 5%.